User`s guide

Rockhopper II series printers – User’s Guide
71
AP-75095, Rev. 2.1, 18/08/2005
Step 4 : When printing by media feed compensation has been finished, press the [CANCEL] key on the
operation panel.
¾ The following messages are displayed on the operation panel.
* Dist. Adj *
Print 1 Change
← F2
Print 2
(1/1)
Step 5 : Press the [F2] key on the operation panel.
¾ The following messages are displayed on the operation panel.
* Change *
90.00 % - 110.00 % +
110.00% -
F2, F4
→ ENTER
Step 6 : Press the [F2] or [F4] key on the operation panel to set the media feed compensation value
based on the printing result in Step 3.
Step 7 : Press the [ENTER] key on the operation panel to confirm the setup value.
¾ The operation panel shifts to the menu of the previous hierarchy.
Step 8 : Repeat step 2-7 until good printing result has been obtained.
Important :
• Some RIP software by default use USER 8 media type. In this case, changing
the step adjust value might seem not to have any effect. You can overcome
this problem by first selecting USER 8 and then changing the step adjust for
USER 8.