User`s guide

Rockhopper II series printers – User’s Guide
70
AP-75095, Rev. 2.1, 18/08/2005
5.3.5. Media feed compensation
Depending on the thickness of media, the media feed amount will change. Printing results may show
following symptoms:
¾ Overlapped printing images
¾ White lines on printing image, etc
For above cases, adjust media feed compensation value with following procedures.
Step 1 : Display Media feed compensation menu on the operation panel by following "Menu setup on the
operation panel".
¾ The following messages are displayed on the operation panel.
* Dist. Adj *
F1 →
Print 1 Change
F3 →
Print 2
Step 2 : Select an item and press the [F1] or [F3] Key.
Setup items
Key Parameters Description
F1 Print 1 Perform printing by media feed compensation at ±
0.10% intervals of setup value from the current
parameter.
Dist. Adj.
F3 Print 2 Perform printing by media feed compensation at ±
0.20% intervals of setup value from the current
parameter (for fine adjustment).
¾ The following messages are displayed on the operation panel.
¾ Print the information on the selected menu.
* Dist Adj *
Printing
→ CANCEL
Step 3 : Confirm printing result by referring to the following figure.