User`s guide

Rockhopper II series printers – User’s Guide
67
AP-75095, Rev. 2.1, 18/08/2005
5. HANDLING THE PRINTER
5.1. INTRODUCTION
This chapter explains how to handle your printer.
5.2. DRAWING FLOW
The following flow chart illustrates the procedure for drawing with the printer.
Refer to each item as necessary.
1. Make the printing data.
Make the printing data using an application software
2. Turn on the printer and load media into the printer.
→ Refer to ‘Media handling’
→ Refer to ‘Using Media’
3. Make the preference setting for drawing with the printer.
→ Refer to ‘Menu setup on the operation panel’
4. Start printing.
→ Refer to ‘Operating from the operation panel’
→ Refer to ‘Operations after printing’
Notes :
• Do not open the front cover during printing. Doing so may stop the printer to draw.
Though the printer resumes printing after you close the front cover, the print quality
cannot be guaranteed.