User`s guide

Rockhopper II series printers – User’s Guide
66
AP-75095, Rev. 2.1, 18/08/2005
4.8.4. Connecting the network interface
The procedure for connecting the network interface is explained below.
To connect the printer to the network environment, follow the steps below.
Caution :
• Follow the instructions below when connecting the network interface cable.
Otherwise, electrical shock or fire may occur.
o Do not touch the connector.
o Do not connect the network cable connector to the interface board having
different specifications.
Step 1 : Turn off the printer.
Step 2 : Plug the connector of the Ethernet cable into the connector of the network interface board at the
back of the printer.
1. Network interface connector 2. Interface cable
Step 3 : Connect the other end of the Ethernet cable to the network.
Notes :
• Refer to "Network interface board operation manual" to use the network interface
board.