User`s guide

Rockhopper II series printers – User’s Guide
65
AP-75095, Rev. 2.1, 18/08/2005
4.8.3. Connecting the Centronics interface
The procedure for connecting the Centronics interface is explained below.
To connect the printer to your computer, follow the steps below.
Step 1 : Turn off the printer and your computer.
Step 2 : Plug the cable connector of the interface cable into the interface connector at the back of the
printer. Squeeze the wire clips together until they lock into place.
1. Centronics interface connector 2. Interface cable
Step 3 : Plug the other end of the cable into the computer's port.
Notes :
• Refer to your computer's manual for the procedure to connect to your computer.