User`s guide

Rockhopper II series printers – User’s Guide
59
AP-75095, Rev. 2.1, 18/08/2005
4.7. TESTPRINTING
Follow the steps below to do a test print and confirm if your printer operates correctly.
Step 1 : Turn the power of the unit ON, and load the media.
Step 2 : Make sure that your printer is in normal status.
Step 3 : Press either the [MENU ↑] key or [MENU ↓] key on the operation panel.
¾ The setup menu is displayed.
* SetupMenu *
InkStatus OriginSet
F3 →
TestPrint MediaSet
(1/6)
Step 4 : Press the [F3] key on the operation panel.
¾ "TestPrint: SetupPrint" is displayed on the LCD.
* TestPrint *
F1 →
Setup NozzleCheck
← F2
F3 →
Adj. Uni-D Adj. Bi-D
← F4
(1/2)
* TestPrint *
F1 →
Palette Maintenance
← F2
(2/2)
Step 5 : Select an item and press the appropriate key.
Setup items
Key name Parameters Descriptions
F1 Setup Perform Setup List.
Refer to ‘Setup List’
F2 Nozzle Check Perform Nozzle check.
Refer to ‘Nozzle Check’
F3 Adj. Uni-D Perform Alignment for the uni-direction printing.
Refer to ‘Alignment’
Test Print (1/2)
F4 Adj. Bi-D Perform Alignment for the bi-direction printing.
Refer to ‘Alignment’
F1 Palette Perform Colour Palette.
Refer to ‘Colour Palette’
Test Print (2/2)
F2 Maintenance Perform Maintenance record.
Refer to ‘Maintenance record’
Step 6 : Print the information on the selected item.
Step 7 : After printing, the printer returns to the normal status.
Ready to print
Heaters Cleaning
Cut&Feed Lever Up
User1 xxxm