User`s guide

Rockhopper II series printers – User’s Guide
58
AP-75095, Rev. 2.1, 18/08/2005
Notes :
• Refer to following sections to load media :
o Loading media
Step 2 : Press one of the following keys on the operation panel, and select the current media type.
¾ When alternating roll/sheet media selection: [F2]
¾ When changing from media loading: [F3]
¾ When changing media type: [F4]
* PaperInitialMenu *
Roll
← F2
F3 →
LeverUp User1
← F4
F2, F4 → ENTER or F3
Setup items
Key Parameters Description
Roll media Media type F2
Sheet media
Alternates the roll media type.
• Roll media: Set when loading roll media.
• Sheet media: Set when loading sheet media.
Lever up Lever Down/Up F3
Lever down
Switches between up and down motion of the pressurizing
lever.
Use this when starting over from the media setup.
User 1
User 2
User 3
User 4
User 5
User 6
User 7
Media Type F4
User 8
Set media type for printing.
For setup values of printing operation, eight settings of "user 1-
8" can be set.
Refer to ‘Menu setup on the operation panel’
Step 3 : Press the [Enter] key on the operation panel.
¾ The media type has been set.
¾ "Media Initial" is displayed on the LCD, and the printer starts the media initial operation.
Notes :
• The printer starts the media initial operation if you :
o Press the [CANCEL] key on the operation panel
o Leave the printer for 10 seconds without doing anything
Paper Initial
User 1
Step 4 : When the media initial operation finishes, the printer moves to normal status.
¾ The setting media loading procedure has been completed.
Ready to print
Heaters Cleaning
Cut&Feed Lever Up
User1 xxxm