User`s guide

Rockhopper II series printers – User’s Guide

AP-75095, Rev. 2.1, 18/08/2005

1. Sheet media 2. Insertion slot

Step 7 : Set the right edge of the media so that it is parallel with the media setting position.

Notes :

• The media set position is a guideline for setting up the media.

• If the right edge of the sheet media is 5 mm or more from the media setting

position, a media set error may occur if the media is not detected. Make sure to set

the right edge of the sheet media within 5 mm of the media setting position.

1. Sheet media 2. Media loading position

Step 8 : Press the [F4] key on the operation panel to lower the pressure rollers.

¾ The MEDIA SET lamp will turn off.

Step 9 : Close the front cover.

Notes :

• Be careful not to pinch your fingers when opening and closing the front cover.