User`s guide

Rockhopper II series printers – User’s Guide
54
AP-75095, Rev. 2.1, 18/08/2005
4.6. MEDIA HANDLING
Media handling, attaching media, and setting media type are explained below.
4.6.1. Loading sheet media
The procedure for loading sheet media is explained below.
You can use the following sheet media with your printer.
50” model 64” model 87” model
Width A4 to 1273 mm max. A4 to 1651 mm max. A4 to 2240 mm max.
Length 1300 mm max.
To load sheet media, follow the steps below.
Notes :
• If roll media is attached to the printer, wind the media up and then load the sheet
media.
Step 1 : Turn the printer on.
Step 2 : The printer starts the initialize operation.
¾ The following message is displayed on the operation panel.
→
Paper End
Heaters Cleaning
Cut&Feed Lever Up
User1 xxxm
Notes :
• If you do not want to use the media detection at the media initialization: Set to
"OFF" in the media detection setup item.
Step 3 : Verify if the sheet lamp on the operation panel is unlit.
Step 4 : Press the [F4] key on the operation panel to lower the pressure rollers.
¾ The MEDIA SET lamp will light (orange).
¾ The following message is displayed on the operation panel.
→
Please Set Paper
Heaters Cleaning
Cut&Feed Lever Up
User1 xxxm