User`s guide

Rockhopper II series printers – User’s Guide
49
AP-75095, Rev. 2.1, 18/08/2005
4.4. TURNING THE POWER ON/OFF
The method to turn the power ON or OFF is described below.
Caution :
• Before powering ON the unit, make sure the waste bottle is installed.
4.4.1. Turning the power ON
Turn the power of the unit ON according to following procedure.
Step 1 : Press the [POWER] key of the operation panel, to turn the unit ON.
¾ The POWER lamp of the operation panel will light (green).
Step 2 : The unit will initial startup operations.
Step 3 : After finishing initial startup operations, the unit will enter the normal operating condition.
Notes :
• If there are any problems during the initial startup operation, the unit will display a
message on the operation panel, and the operation may stop. If the operation
stops, refer to "Troubleshooting", and take the appropriate actions.
4.4.2. Turning the power OFF
Turn the power of the unit OFF according to the following procedure.
Step 1 : Verify the following regarding the operational condition of the unit.
¾ There is no printing operation being performed.
¾ The operation panel is in a normal status.
Step 2 : Press the [POWER] key of the operation panel to turn the unit OFF.