User`s guide

Rockhopper II series printers – User’s Guide
47
AP-75095, Rev. 2.1, 18/08/2005
Step 3 : Plug the cable correctly to the outlet.
Important :
• Do not attempt to plug in electrical plugs with wet hands. Doing so may
result in electrical shock.
• Be sure to use the specified voltage (AC 100V-120V/220V-240V). Otherwise,
electrical shock or fire may occur.
• Use electricity directly from a power outlet (AC 100V-120V/220V-240V). Do not
put many loads on one electrical output. Otherwise, heat may be generated
and cause fire.
• Be sure to use an outlet with an earth terminal, and use the terminal
correctly. Otherwise, electrical shock or fire may occur.
• Do not connect earth cables in the following areas :
o Gas pipes. Doing so may cause fire or an explosion.
o Earth terminals for telephone lines or lightening rods. Doing so may
cause a large flow of voltage if lightening occurs.
o Water pipes or faucets. If there is a plastic part in the pipe, the earth
will not work correctly.
Caution :
• Follow the instructions below when handling the power plug. Otherwise, fire may
occur.
o Wipe away dust and any other residue before inserting the plug.
o Ensure that the plug is firmly inserted as far as it will go.
• Ensure that the plug has been disconnected from the power socket when it is not
used for a long time.
• Earth wires must be connected to wires or terminals that fulfill the conditions :
o Earth terminals of power socket
o Earth wires with copper morsel that is at least 650 mm under ground
Notes :
• If you cannot use earth terminals or find any of them, contact the shop where you
bought your printer.
• Do not unplug the power cable when the printer is on. If the power cable has been
unplugged, leave the printer for at least 1 minute before plugging the cable in
again.
1. Power cable