User`s guide

Rockhopper II series printers – User’s Guide
45
AP-75095, Rev. 2.1, 18/08/2005
4. PREPARING FOR A JOB
4.1. INTRODUCTION
The procedures needed before using the printer are explained below.
4.2. CONNECTING THE POWER CABLE
The connection procedure for the power cable is explained below.
Important :
• Make sure that the distributed power cable is used. Use of a different cable
may result in electric shock or fire.
• Do not use a damaged power cable. Doing so may result in electric shock or
fire.
• The disconnect device is the plug on the power supply cord.
Caution :
• Be careful of the following when handling the power cable.
o Do not make any modifications to the power cable.
o Do not place anything heavy on the power cable.
o Do not bend, twist, or pull the cable.
o Do not wire the cable near equipment that generates heat.
Notes :
• If the power cable is damaged, contact one of the following :
o The shop where you bought your MUTOH printer.
o Your local MUTOH dealer.