User`s guide
Rockhopper II series printers – User’s Guide
43
AP-75095, Rev. 2.1, 18/08/2005
3.5. INSTALLATION
Product installation is explained below.
3.5.1. Choosing a place for the printer
Install the unit on a proper location referring to the following.
Important :
•
Do not place the printer on a location under the following conditions. Doing
so may cause the product to fall, become damaged, or cause injury.
o
Unstable surfaces
o
Slanted surfaces
o
Locations that are subject to vibration from other product
•
Do not stand on the printer or place any heavy objects on it. Doing so may
cause it to fall over, become damaged, or cause injury.
•
Do not cover the ventilation hole of the printer with cloth, such as a blanket
or table cloth. Doing so could prevent the printer from ventilating and cause
fire.
•
Keep the printer away from humid and dusty areas. Humidity may result in
electrical shock or fire.
3.5.1.1. Installation environment Requirements
Choose a place for printer installation following the requirements in the table below.
50” model 11.7m² (133ft²) or larger. Frontage of 4.3m (14.3ft) or greater.
64” model 12.7m² (144ft²) or larger. Frontage of 4.7m (15.7ft) or greater.
Area
87” model 14.3m² (162ft²) or larger. Frontage of 5.3m (17.7ft) or greater.
Floor loading capability 2490Pa (300kg/m²) or over
Voltage AC100V - 120V or AC220V – 240V
Frequency 50/60Hz±1Hz
Electrical
Capacity AC100V - 120V: 12A or more
AC220V - 240V: 6A or more
Recommended
working environment
Temperature: 25°C
Humidity: 40% to 60%, without condensation
Operational conditions Temperature: 18°C to 35°C
Humidity: 40% to 60%, without condensation
Rate of change Temperature: No more than 2°C per hour
Humidity: No more than 5% per hour
Environmental
Storage environment Temperature: -20°C to 60°C
Humidity: 5 to 85%, without condensation (When ink has
been discharged.)
Notes :
• Avoid the following temperature and humidity conditions. Otherwise, printed
images may appear differently from what you expect:
o Places where sudden changes in temperature and humidity are expected,
even though the condition is within the range written above.
o Places where direct sunlight or excessive lighting are expected.
o Places where air conditioners blow directly.
• MUTOH recommends that the printer should be installed where air conditioning can
be adjusted easily.