User`s guide

Rockhopper II series printers – User’s Guide

AP-75095, Rev. 2.1, 18/08/2005

3.3.3. Fixing the printer body onto the stand

After installation of the unit onto the stand, please check if there is no gap between the printer body and the

stand.

When you notice that there is a gap between the printer body and the stand, please follow the instructions

mentioned below to minimize this gap.

Notes :

Please find enclosed three types of spacers.

• 5 pieces : 0.3 mm spacer

• 5 pieces : 0.5 mm spacer

• 5 pieces : 1.0 mm spacer

Step 1 :

In case there is a gap between the stand and the printer body, loosen the screw fixing the stand

to the unit.

Step 2 :

Insert a spacer in-between the stand and the printer body.

Step 3 :

Fully insert the spacer between the stand and the printer body.

Step 4 :

Tighten the screw.