User`s guide
Rockhopper II series printers – User’s Guide
35
AP-75095, Rev. 2.1, 18/08/2005
3.3. ASSEMBLY
The assembly of this product is described below.
Caution :
When assembling this product, always work with at least 4 people or more.
3.3.1. Assembling the stand
Assemble the stand according to the following procedure.
Step 1 : Place the stand upside down as shown in the figure.
Step 2 : 2. Install the foot to the stay according to the following procedure.
A ) : Attach two feet on the bottom of the stay as shown.
B ) : Attach the hexagon socket head cap screws (M6 x 30: each 4) to each foot.
C ) : Using the assembly tool, tighten the hexagon socket head cap screws to install the feet.
1. Stay 2. Foot
3. Hexagon socket head cap screw (M6 x 30)
Step 3 : Assembling the stand has been completed.