User`s guide

Rockhopper II series printers – User’s Guide
31
AP-75095, Rev. 2.1, 18/08/2005
3. SETTING UP THE UNIT
3.1. UNPACKING
The unpacking procedure is described below.
The product is sent to the user in 2 boxes, 1 for the main unit and the other for the stand.
Caution :
• When unpacking this product, always work with at least 4 people.
• When removing this product from the packaging box, always remove the vinyl
plastic, and hold on the side of the product. Holding the unit over the vinyl plastic
wrapping can result in slippage and dropping the unit, resulting in damage.
3.1.1. Unpacking packaging box of the main unit
Unpack the package of the main unit according to the following procedure.
Step 1 : Move the packaging of the main unit to the location to unpack.
Step 2 : Remove the restraining bands.
Step 3 : Remove the top board and take out the packaging material (right upper side and left upper side).
1. Top board 2. Packaging material (right upper side)
3. Packaging material (left upper side)