User`s guide

Rockhopper II series printers – User’s Guide
29
AP-75095, Rev. 2.1, 18/08/2005
2.4.3. Changing the printer status
To change the printer status, follow the steps below.
(1) Changing the status from normal to the setting menu display
Press either [MENU Ç] or [MENU È] on the operation panel when the printer is in normal status.
¾ The display of the operation panel changes to the Setting menu display.
Notes :
• Refer to "Setup menu" for details of the setting menu.
(2) Changing the status from the setting menu display to normal
Take one of the following actions when the printer is in the setting menu display to change the operation
panel display to normal one.
¾ Press the [CANCEL] key on the operation panel.
¾ Leave the printer as it is for 3 minutes when the status is in the setting menu display.
Ready to print
Heaters Cleaning
Cut&Feed Lever Up
User 1 xxxm
[MENU ↑] or [MENU ↓]
↓
↓
↑
↑
[CANCEL] or leave the printer as it is
for 3 minutes
* SetupMenu *
InkStatus OriginSet
TestPrint MediaSet
(1/7)
Notes :
• Refer to ’Status messages" for details of displaying the printer status.