User`s guide

Rockhopper II series printers – User’s Guide
23
AP-75095, Rev. 2.1, 18/08/2005
2.3.2. Back
No. Name Function
1 AC inlet This is the inlet interface to which the power plug is connected.
2 Interface connector This is the connector to which the interface cable is connected.
3 Foot switch connector This is the connector to which the foot switch cable is attached.
4 Insertion slot This is the slot for inserting media when loading it.
5 Interface slot 1 The network interface board attaches here.
6 Interface slot 2
7 Interface slot 3
This is not used for this printer.
Close it with the cover.
8 Hard disk slot The hard disk attaches here. When not using a hard disk, keep the
cover closed.
9 Nameplate rating The type, name, serial number, rating and other details of the printer are
labelled here.
10 Rear Heater Supports the media during printing and houses the pre-heaters.