User`s guide

Rockhopper II series printers – User’s Guide
185
AP-75095, Rev. 2.1, 18/08/2005
1. Screws 2. Expansion memory cover
Step 3 : Push the tab on the right side of the memory expansion slot on the board to remove the memory
from the board.
1. Memory 2. Expansion slot
Step 4 : Insert the memory card into the expansion slot, as shown on the figure below.
¾ Align the notched side of the memory card with the slot.
Notes :
• The expansion slot has a feature to prevent improper insertions. If the
expansion slot does not go in, do not force it. This can damage the expansion
slot.
1. Expansion slot 2. Expansion memory
Step 5 : Reinstall the maintenance cover.
Step 6 : Connect the disconnected cables.
Notes :
• Refer to "Connecting the power cable" for details on how to install the power
source cable.