User`s guide

Rockhopper II series printers – User’s Guide
170
AP-75095, Rev. 2.1, 18/08/2005
7.5. TRANSFER AND TRANSPORTATION
This section explains transferring and transporting the printer.
7.5.1. Transferring the printer
Following are instructions for transferring the printer.
Caution :
• Keep the printer horizontally during transfer.
• Do not tilt the printer, stand it against a wall, or turn it upside down. Doing so
may cause ink to leak inside the printer. Also, movement after transport is not
covered by the warranty.
• Have two or more people to transport the printer.
(1) Before the transfer
If you are using the stand, follow the steps below to transfer the printer.
Step 1 : Make sure the printer is turned off.
Step 2 : Make sure the head is in the right edge position (capping position).
Step 3 : Disconnect the power cable and all other cables.
Step 4 : Release the locks on the casters.
Step 5 : The four adjusters are turned in the direction shown on the diagram.
Step 6 : Transfer the printer.
Notes :
• The caster attached to the stand has been designed for transferring the printer
during short distances.
1. Adjuster 2. Caster