User`s guide

Rockhopper II series printers – User’s Guide
165
AP-75095, Rev. 2.1, 18/08/2005
7.3.4. Cleaning the cleaning wiper
Following are instructions for cleaning the cleaning wiper.
Follow the steps below to clean the cleaning wiper.
Step 1 : Replace an ink cassette.
Notes :
• For instructions on replacing an ink cassette, refer to "Replacing ink cassettes".
Step 2 : If the printer is turned on, make sure of the following
¾ Printing or other operations are not performed.
¾ Make sure that the display on the operation panel shows the normal status.
¾ The MEDIA SET light on the operation panel goes off.
Step 3 : Follow "Menu setup on the operation panel" and display the cleaning wiper menu on the
operation panel.(Refer to ‘Wiper clean menu’)
* SetupMenu *
F1 →
CutterChg. WiperClean
← F2
F3 →
TankChg. TubingFlush
← F4
(6/7)
* WiperClean *
No Yes
← F2
(1/1)
Step 4 : Select "Yes" by pressing the [F2] key on the operation panel.
¾ The printer enters the cleaning wiper mode.
¾ The carriage moves to the waiting position for cleaning the wiper.
¾ The following message is displayed on the operation panel.
Notes :
• If you did one of the things mentioned in step 5, the printer does not clean the
cleaning wiper and returns to the setup menu.
• Press the [CANCEL] key on the operation panel.
• Select "No" and pressed the [F1] key on the operation panel.
* WiperClean *
Changed wiper?
→ ENTER