User`s guide

Rockhopper II series printers – User’s Guide
155
AP-75095, Rev. 2.1, 18/08/2005
7.2.2. Replacing the cutting blade
Read following information on when and how to replace the cutting blade.
(1) Replacement time
Replace the cutting blade under the following conditions.
a. Media cannot be cut cleanly
The message "media Cut Error" appears on the operation panel if a media cutting error occurs.
→
Paper Cut Error
Heaters Cleaning
Cut&Feed LeverUp
User1 xxxm
b. When the cut edge has scuffing
(2) Replacement procedure
Follow the steps below to replace the cutting blade.
Step 1 : If the printer is turned on, make sure of the following
¾ Printing or other operations are not performed.
¾ Make sure that the display on the operation panel shows the normal status.
¾ The MEDIA SET light on the operation panel goes off.
Step 2 : Follow "Menu setup on the operation panel" and display the cutting blade replacement menu on
the operation panel.(Refer to ‘Cutter change menu’)
* CutterChg. *
No Yes
← F2
(1/1)
Step 3 : Select "Yes" by pressing the [F2] key on the operation panel.
¾ The printer prepares for cutting blade replacement.
¾ The carriage moves to the cutting blade replacement position.
¾ The following message is displayed on the operation panel.
Notes :
• If you did one of the things mentioned in step 3, the printer does not replace the
cutting blade and returns to the setup menu.
• Press the [CANCEL] key on the operation panel.
• Select "NO" then press the [F1] key on the operation panel.
* CutterChg. *
Changed cutter?
→ ENTER