User`s guide

Rockhopper II series printers – User’s Guide
149
AP-75095, Rev. 2.1, 18/08/2005
6.4. WHEN MEDIA JAMS OCCUR
If the loaded media gets jammed in the printer, follow the steps below to remove the media.
6.4.1. How to remove a piece of media (cut media)
Step 1 : Press [F4] to raise the pressure rollers.
• The MEDIA SET lamp will turn on (orange).
• The following message is displayed on the operation panel.
→
Please Set Paper
Heaters Cleaning
Cut&Feed LeverUp
User1 xxxm
Notes :
• For raising or lowering the pressure rollers, you can use the foot switch instead
of the operation panel.
1. Foot Switch
Step 2 : If a piece of media or media dust is stocked in the printer, open the front cover and remove the
piece of media or media dust.
Caution :
• Be sure not to pinch your fingers while opening and closing media cover.
1. Front Cover
Step 3 : If there is an error requiring a restart, power the printer OFF and ON again.
6.4.2. How to remove a piece of media (roll media)
To remove a piece of roll media, please refer to the User’s Guide “Handling roll media on a Falcon II series
printer and Rockhopper II series printer”.