User`s guide

Rockhopper II series printers – User’s Guide
135
AP-75095, Rev. 2.1, 18/08/2005
Step 4 : Press the [F1] key on the operation panel.
Media Cut?
ENTER or CANCEL
¾ The media is cut at its position when the [ENTER] key has been pressed.
Notes :
• If the front edge of the roll media is not straight when you load new roll media, you
should cut its edge.
• Cutting blades are consumable. Replace them at regular intervals following
"Replacing the cutting blade".
5.6.2. Media cutting procedure
This section explains how to cut the media manually.
When "Manual" is set in the media cut menu, the media can be cut manually.
Cut the media according to the following procedure.
Step 1 : Make sure that the MEDIA SET lamp on the operation panel is off.
Notes :
• After printing, the media is automatically transferred to the media cutting position.
Ready to print
Heaters Cleaning
F3 →
Cut&Feed LeverUp
User1 xxxm
Step 2 : Press the [F3] key on the operation panel.
¾ Shift to the cut and feed menu.
* Cut&Feed *
Cut
F3 →
Forward Backward
← F4
Step 3 : Feed media to the desired position according to the procedure in "Feeding media".
* Cut&Feed *
F1 →
Cut
Forward Backward
← F4