User`s guide

Rockhopper II series printers – User’s Guide
132
AP-75095, Rev. 2.1, 18/08/2005
5.5.3. Feeding media
When you want to feed media forward or backward, follow the steps below:
Step 1 : Verify the following regarding the condition of the printer.
¾ It is not currently printing
Ready to print
Heaters Cleaning
F3 →
Cut&Feed LeverUp
User1 xxxm
Step 2 : Press the [F3] key of the operation panel.
¾ To shift to the feed & reel menu.
* Cut&Feed *
Cut
F3 →
Forward Backward
← F4
Step 3 : Press the [F3] key or the [F4] key on the operation panel.
¾ The product will perform following operations:
Setup items Key name Parameters Description
F3 Forward Feeds media forward. Cut & Feed
F4 Backward Feeds media backward.
Notes :
• If "Take-Up Roll" is set in the media detection setup menu, the product will not
operate even if the [F4] key has been pressed.
Refer to ‘Media detection menu’
5.5.4. Operating the pressure rollers
When you want to switch the up and down movement of the pressure rollers follow the steps below.
Step 1 : Press the [F4] key on the operation panel.
¾ The printer works as follows.
Ready to print
Heaters Cleaning
Cut&Feed LeverUp
← F4
User1 xxxm
Status of the printer Operation after the [F4] key has been pressed
• The pressure rollers have been lowered
• The MEDIA SET lamp turns off.
• The pressure rollers are lifted
• The MEDIA SET lamp will turn on (orange).
• The pressure rollers have been raised.
• The MEDIA SET lamp turns on (orange).
• The pressure rollers are lowered.
• The MEDIA SET lamp will turn off.