User`s guide

Rockhopper II series printers – User’s Guide
131
AP-75095, Rev. 2.1, 18/08/2005
5.5.2.4. Change the dryer temperature
To change the temperature of the dryers, press the [F4] key on the operation panel. The display will mention
the following:
* Drier (D) *
OFF – 50°C +
← F2
50°C -
← F4
F2, F4
→ ENTER
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the rear heater settings.
5.5.2.5. Activate/ deactivate heaters.
In the second menu, press the [F1] key to activate or deactivate all heating elements.
In case the heating elements are activated, the display will mention “SET OFF”. By pressing the [F4] key
you can deactivate the heating elements. The display will mention “SET ON”.
In case the heating elements are deactivated, the display will mention “SET ON”. By pressing the [F4] key
you can activate the heating elements. The display will mention “SET OFF”.
Please note that after finishing a printing job (and no other print job is sent to the printer the heating elements
will keep their temperature for approximately 6 minutes. After 6 minutes the heating elements are powered
OFF.