User`s guide

Rockhopper II series printers – User’s Guide
130
AP-75095, Rev. 2.1, 18/08/2005
5.5.2.1. Change the heater temperature
To change the temperature of the heater, press the [F1] key on the operation panel. The display will mention
the following:
* Heater (A) *
OFF – 50°C +
← F2
50°C -
← F4
F2, F4
→ ENTER
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.
5.5.2.2. Change the fixer temperature
To change the temperature of the fixer, press the [F2] key on the operation panel. The display will mention
the following:
* Fixer (B) *
OFF – 70°C +
← F2
50°C -
← F4
F2, F4
→ ENTER
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.
5.5.2.3. Change the post fixer temperature
To change the temperature of the post fixer, press the [F3] key on the operation panel. The display will
mention the following:
* Post Fixer (C) *
OFF – 70°C +
← F2
50°C -
← F4
F2, F4
→ ENTER
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.