User`s guide

Rockhopper II series printers – User’s Guide
127
AP-75095, Rev. 2.1, 18/08/2005
5.5. OPERATING FROM THE OPERATION PANEL
This section describes functions operated on the operational panel when the printer is in the normal status.
Notes :
• For information of the name and function of each key, refer to "Operation panel".
5.5.1. Controlling the heater elements on the Rockhopper II printer
If you want to change or check the heater elements, follow the steps below.
Step 1 : Press the [F1] key on the operation panel.
¾ The printer works as follows.
Ready to print
F1 →
Heaters Cleaning
← F2
F3 →
Cut&Feed LeverUp
← F4
User1 xxxm
By pressing the [F1] key, you will have direct access to control or change the heaters
temperatures.
After pressing the [F1] key in the normal status, the operation panel will mention the following:
* Heaters *
F1 →
A : S 50 – R 50
F3 →
D : S 50 – R 50 SET ON
← F4
heater message
The ‘heater message’ can be one of the following:
Heater standby
Heater warming up
Heater ready
Notes :
• Previous firmware mention: ‘Heater standby’, ‘Heater ON’, ‘Heater OFF’, ‘Heater ON
(A)’ and ‘Heater ON (D)’.
‘A’ stands for the rear heaters.
‘D’ stands for the dryers.
‘S’ stands for the Set-temperature (requested temperature).
‘R’ stands for the Real-temperature (actual temperature).