User`s guide

Rockhopper II series printers – User’s Guide
126
AP-75095, Rev. 2.1, 18/08/2005
Notes :
• The number of the heads refer to the numbers above a nozzle check.
If you select Head 1-2, the head moves away from the capping station and the pump motors start
turning counter clockwise. On the display following text appears:
*TubingFlush*
Tubing flushed?
→ ENTER
The pumps turn for a certain time. Press ENTER as they stop. To stop the pump motors earlier,
press ENTER during the pump cycle. The following display will appear.
*TubingFlush*
Head 1 – 2
Î To start the pumps again, select Head 1-2.
Î To stop the tubing flush, press CANCEL. The head carriage moves back to the capping
station.
•
Tubing flush for 8 head printer
*TubingFlush*
Head 1 – 2 Head 3 -4
If you select Head 1-2, pump 1 of pump motor 1 and pump 1 of pump motor 2 starts pumping. The
pump motors turn clock wisely. If you select Head 3-4, pump 2 of pump motor 1 and pump 2 of pump
motor 2 starts pumping. The pumps turn counterclockwisely
5.4.97. Version Check menu
To check the installed firmware version.
* VersionCheck *
RJ : rh x.xx
Heat Sys : y.yy
Setup items
Parameters Description
Version Check - • [CANCEL] key: shift to the previous hierarchy menu.
Refer to ‘Setup menus’
x.xx = firmware version of the RJ main board.
y.yy = firmware version of the heating board.