User`s guide

Rockhopper II series printers – User’s Guide
103
AP-75095, Rev. 2.1, 18/08/2005
5.4.53. Roll Media setup menu
To perform various settings for roll media.
* RollSetup *
F1 →
Disable Roll1
← F2
F3 →
Roll2 Roll3
← F4
(1/1)
Setup items
Parameters Description
Disable Set this when roll media setup is not used.
Roll media 1
Roll media 2
Roll media 3
For each setup value of roll media, 3 settings of "Roll
media 1" - "Roll media 3" can be set.
Refer to ‘Roll media length menu’
Roll media setup
- • [CANCEL] key: To shift to the previous hierarchy
menu.
Refer to ‘Setup menu’
5.4.54. Roll media length menu
To set roll media length.
* Roll1 *
1 m – 99 m +
← F2
30m -
← F4
F2, F4
→ ENTER
Setup items
Parameters Description
Roll media 1-4 1 m to <30 m>to 99 m To change roll media length by operating the
following keys.
• [F2] key: Increases the setup value.
• [F4] key: Decreases the setup value.
• [ENTER] key: Confirms the setup value, shifts to the
previous hierarchy menu.
• [CANCEL] key: Cancels the setup value, shifts to
the previous hierarchy menu.
Refer to ‘Roll Media setup menu’
5.4.55. Centronics menu
To set communication mode to Centronics interface.
* Centro. *
F1 →
Centro. BiCentro.
← F2
Current parameter →
- BiCentro. - (1/1)
Setup items
Parameters Description
Centronics To set communication mode to Centronics mode.
<Bi Centro> To set communication mode to Bi-Centronics mode.
Centronics
- To shift to the previous hierarchy menu.
Refer to ‘Setup menu’