User`s guide

Rockhopper II series printers – User’s Guide
100
AP-75095, Rev. 2.1, 18/08/2005
5.4.46. Layout method menu
To set the layout method for printing data.
* Direct... *
F1 →
Command MAX-MIN
← F2
Current parameter →
- Command - (1/1)
Setup items
Parameters Description
<Command> If there is a page size specification command for the
printing data, the media size is determined from the
region specified by the page size specification
command to position the data.
MAX-MIN Regardless origin and page size specification
commands, the media size on which data is collected
is determined by the maximum and minimum values
of the actual data, and the data is located so that the
center of the region is the same as the center of the
media.
Layout method
- To shift to the previous hierarchy menu.
Refer to ‘Layout setup menu’
5.4.47. Joint printing menu
To set joint printing.
* Joint *
F1 →
ON OFF
← F2
Current parameter →
- OFF - (1/1)
Setup items
Parameters Description
<Off> Does not perform stitching print.
On Performs stitching print
Joint
- - Shifts to the previous hierarchy menu.
Refer to ‘Layout setup menu’
5.4.48. Cutting position Menu
To set the media cutting position after printing has been finished.
* CutPos. *
F1 →
Standard Data
← F2
Current parameter →
- Data - (1/1)
Setup items
Parameters Description
Standard To cut the media to fit the media width, so that it
meets the regulated size.
<Data> To cut the media according to the size of the printing
data.
Cutting position
- - Shifts to the previous hierarchy menu.
Refer to ‘Layout setup menu’