Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.8.4 Replacing the Y Paper Sensor Assembly

Step 1 : Remove the Front Cover. Refer to “Removing Front Cover”

Step 2 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 3 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”

Step 4 : Disconnect connector J204 (PEDGE) from the Head Board.

Step 5 : Remove the Head Cable keeper.

Step 6 : Remove the Paper Sensor.

Step 7 : To install removed components, reverse removal procedure.

Caution:

 Be careful not to over-tighten when refitting the Waste Fluid Box Detector Switch

Assembly.

 Tightening torque is 29,4 N.cm (3 kg.cm).