Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.8.3 Replacing the Print Head Assembly and Head Cable (color)

Step 1 : Carry out Head Cleaning. Refer to “Head Cleaning Procedure 1”

Step 2 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 3 : Remove the Front Cover. Refer to “Removing Front Cover”

Step 4 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”

Step 5 : Disconnect connectors J207 (Head BK) and J208 (HEAD COL) from the Head Board.

Step 6 : Remove the Tube Fixer.

Step 7 : Remove the coupling screw and shift the ink tube up out of the way.

Step 8 : Remove the damper fixer (2 fastening screws).

Step 9 : Remove the colour damper (3 pieces).

Caution:

 When removing the black damper, be careful not to grip the transparent film surface

of the damper. Rough handling of the transparent film may cause an air leak and

prevent printing.

Step 10 : Remove the head (colour) (1 fastening screw).

Step 11 : Remove the Cable by disconnecting it from the Cursor.