Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

Nr. Description

1 Head (Black)

2 Fastening screw

3 Transparent Film Surface

Step 11 : Remove the Cable by disconnecting it from the Cursor.

Step 12 : Remove the Head an disconnect the Head Cable.

Step 13 : Remove the Cable from the Head.

Step 14 : To install removed components, reverse the removal procedure.

Caution:

 Before the new head is fitted, check the head rank (the

five digits of the number on the side of the head are the

rank) and write the number with a marker pen on the

black head cable (Delete the old head rank by drawing

two lines trough the number).

 When fitting the head into the head mount, put the black

head cable on top.

Adjustments:

1. Reset the head nozzle ejector count

Please refer to “How to Initialize Parameters”

2. Carry out initial filling.

Please refer to “How to enter Head Rank”

CAUTION :

Wait at lease 30 minutes after the initial filling before printing. Otherwise the printing

quality can not be assured.

3. Carry out the Print Head (Black) Tilt Adjustment

Please refer to “Adjusting the Tilt of the Print Head(Black)”