Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.8 REPLACEMENT OF CARTRIDGE AREA

4.8.1 Replacing the Cutter Solenoid Assembly

Step 1 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 2 : Remove the Front Cover. Refer to “Removing Front Cover”

Step 3 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”

Step 4 : Disconnect connecter J206 (SOL) from the Head Board.

Step 5 : Remove the Head Cover. Refer to “Removing Head Cover”

Step 6 : Move the Head 20 to 30 cm to the left.

Step 7 : From the back, remove the two fastening screws holding the solenoid.

Step 8 : Remove the cutter cap, remove the solenoid.

Step 9 : To install removed components, reverse the removal procedure.

Caution:

 Be careful not to lose the O-rings. Initial filling and printing can not be done if the O-

rings are missing.

 Don’t use a tool to tighten the coupling screws but get them as tight as possible with

your fingers. If you use a tool, there is a risk of breaking the plastic taps.