Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.7.5 Replacing the Ink Tubes

Step 1 : Carry out Head Cleaning and empty the ink inside the tubes. Refer to “Head Cleaning Procedure”

Step 2 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 3 : Remove the Front Cover. Refer to “Removing Front Cover”

Step 4 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”

Step 5 : Remove Flexible Guide Fixer H (2 fastening screws).

Step 6 : Remove Flexible Guide Fixer C (2 fastening screws).

Step 7 : Remove ht four jointing screws and O-rings on the Flexible Cable Guide.

Step 8 : Remove the four jointing screws and O-rings below the cursor.

Caution:

 Be careful not to lose the O-rings. Initial filling and printing can not be done if the O-

rings are missing.

 Don’t use a tool to tighten the coupling screws but get them as tight as possible with

your fingers. If you use a tool, there is a risk of breaking the plastic taps.