Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.7.3 Replacing the Detector Assembly (Black, Yellow, Magenta and

Cyan)

Step 1 : Remove the Cartridge Frame Assembly. Refer to “Replacing Cartridge Frame Assembly”

Step 2 : Remove paper guide R. Refer to “Removing Paper Guide R”

Step 3 : Disconnect junction board connectors J402 (Detector BK), J403 (Detector C), J404 (Detector M),

J405 (Detector Y) and J406 (Ink ID BK), J407 (Ink ID C), J408 (Ink ID M), J409 (Ink ID Y).

Refer to “Replacing Ink ID Assembly BYMC”

Step 4 : Remove the Ink Detector Switch on the Detector Assembly (One fastening screw).

Step 5 : Remove the switch that determines whether the Cartridge Frame Assembly is present (One

fastening screw).

Step 6 : To install removed components, reverse removal procedure.

Caution:

 Be careful not to over-tighten when refitting the Waste Fluid Box Detector Switch

Assembly. Tightening torque is 29.4 Ncm (3 kg.cm)

Step 7 : Remove the Ink Tube keeper (2 fastening screws).

Note:

 The same procedure applies to Black, Yellow, Magenta and Cyan

4.7.4 Replacing the Y Cable