Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.7.2 Replacing the Ink ID assembly (Black, Yellow, Magenta, Cyan)

Step 1 : Remove cartridge.

Step 2 : Remove Front Cover. Refer to “Removing Front Cover”

Step 3 : Remove Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 4 : Remove Y Rail Cover. Refer to “Removing Y Rail Cover”

Step 5 : Remove Paper Guide R. Refer to “Removing Paper Guide R”

Step 6 : Disconnect Junction Board Connector J406 (Ink ID BK), J407 (Ink ID C), J408 (Ink ID M), J409

(Ink ID Y).

Step 7 : Remove Flexible Cable Attachment C (two fastening screws).

Step 8 : Remove Y Rail Cover Support . Refer to “Replacing Cartridge Frame Assembly”

Step 9 : Remove the Cartridge Mounting Plate from X Reinforcement R. Refer to “Removing

Step 10 : Slide the Cartridge Unit a little way forward and lift it up. Refer to “Replacing Cartridge Frame

Assembly”

Step 11 : Remove Ink ID Sensor 1 Assembly (BK) (one fastening screw).

Ink ID Sensor Assemblies 2 to 4 are handled as follows:

Step 12 : Remove the Cartridge Mounting Plate.

Step 13 : Cut the cable tie holding the Ink ID Sensor Cables.

Step 14 : Undo the screw joints on each cartridge pipe in the Cartridge Frame Assembly.

Step 15 : Remove the Cartridge Unit by pulling it forward.

Step 16 : Remove the Cartridge Frame Assembly.

Step 17 : Remove Ink ID Sensor Assemblies 1(C) to 4 (Y) (one fastening screw).

Step 18 : To install removed components, reverse removal procedure.