Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

Step 19 : Move the Cartridge Slide in the direction shown by Arrow B.

Step 20 : Remove the Cartridge Slide from the Cartridge Frame Assembly.

Step 21 : To install removed components, reverse removal procedure.

Caution:

 Don’t use a tool to tighten the coupling screws but get them as tight as possible with

your fingers. If you use a tool, there is a risk of breaking the plastic taps

Adjustments:

1. Carry out the initial filling.

Please refer to “How to enter Head Rank”

CAUTION :

Wait at lease 30 minutes after the initial filling before printing. Otherwise the printing

quality can not be assured.

2. Carry out a test print

Please refer to “Test procedures, test 8”

3. Fit a new Waste Fluid Box

Please refer to “How to enter Head Rank”.

CAUTION:

About 100 cc of waste fluid will be expelled into the Waste Fluid Box from head cleaning

and initial filling. Fit a new Waste Fluid Box.

Please refer to “Replacing Waste Fluid Box”.

The message “Change Tank?” will appear on the panel display. You should confirm by

answering “YES”