Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.6.4 Replacing the Pump Assembly

Step 1 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 2 : Remove the Front Cover. Refer to “Removing Front Cover”

Step 3 : Remove the Y rail Cover. Refer to “Removing Y Rail Cover”

Step 4 : Remove the Front Paper Guide. Refer to “Removing Front Paper Guide”

Step 5 : Remove the Panel Mounting Plate. Refer to “Replacing Pump Motor Assembly 1-6”

Step 6 : Take out the Maintenance Station Assembly. Refer to “Replacing Cap Assembly”

Step 7 : Disconnect and remove the tubes between the Pump Assembly and the Cap Assembly.

Step 8 : Remove the Cap Assembly.

Step 9 : Pick out the Transfer Gear Shaft with your finger.

Caution :

 Be careful not to break the claw on the Transfer Gear Shaft.

Step 10 : Remove the Pump assembly (1 fastening screws) up and to the right.

Step 11 : To install the removed components, reverse the removal procedure.