Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.6.2 Replacing the Cap Assembly

Step 1 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 2 : Remove the Front Cover. Refer to “Removing Front Cover”

Step 3 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”

Step 4 : Remove the Front Paper Guide. Refer to “Removing Front Paper Guide”

Step 5 : Remove the Panel Mounting Plate. Refer to “Replacing Pump Motor Assembly 1-6”

Step 6 : Remove the Cap Assembly Spring.

Step 7 : Disconnect the two tubes from the Cap Assembly.

Step 8 : Grasp the plug on the right side of the Cap Assembly, lift it up and remove the right side of the

Cap.

Step 9 : Grasp the centre section of the Cap Assembly, lift it up and take out the Cap.

Caution :

 Be careful not to touch the surfaces of the Cap or the Cleaner ASP.

Step 10 : To install the removed components, reverse the removal procedure.

Caution :

 When inserting tubes on the Cap Assembly, turn the tubes clockwise trough 45 to

90 degrees. If not, you may be unable to lower the Cap Assembly to the bottom.