Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.5 REPLACEMENT OF CR DRIVING SECTION COMPONENTS

4.5.1 Replacing the Y Motor Assembly

Step 1 : Remove the Left and Right Covers. Refer to “Removing Left and Right Covers”

Step 2 : Remove the Rear Paper Guide. Refer to “Removing Rear Paper Guide”

Step 3 : Remove the Steel Belt. Refer to “Replacing Steel Belt”

Step 4 : Open the Control Box. Refer to “Opening and Closing Control Box”

Step 5 : Disconnect connector J120 (YMOT) from the Main Board Assembly.

Step 6 : Remove the Y Motor Assembly (3 fastening screws).

Step 7 : To install the removed components, reverse the removal procedure.

Tip:

 Since the Y Motor Assembly Cable passes below the Cartridge Unit, the work will be

easier if you remove the two Cartridge Base Screws and push it back.