Specifications

Rockhopper 38 – Maintenance Manual
67
AP-74038, Rev. 1.1, 25/01/05
4.4.13 Platen Height Adjustment
Step 1 : Adjust the rail height jig. Refer to “Measuring the Y Rail Fitting Precision”
Mount the rail height jig on the standard base and set the dial gauge to “0”
Mount the rail height gauge over the ribs at both ends of the platen, loosen the platen retaining
screws and adjust the platen up and down until the dial gauge reads 2.6 to 2.7 mm.
STANDARD VALUE : 2.6 to 2.7 by dial gauge
Nr. Description
1 Adjusting screws
2 Platen