Specifications

Rockhopper 38 – Maintenance Manual
63
AP-74038, Rev. 1.1, 25/01/05
4.4.10 Replacing the Pressure Assembly
Step 1 : Remove the right and left covers. Refer to “Removing Right and Left Covers”
Step 2 : Remove Unit Panel Cover. Refer to “Removing Unit Panel Cover”
Step 3 : Remove Front Cover. Refer to “Removing Front Cover”
Step 4 : Remove Y rail cover. Refer to “Removing Y Rail Cover”
Step 5 : Remove Front paper guide. Refer to “Removing Front Paper Guide”
Step 6 : Remove Rear paper guide. Refer to “Removing Rear Paper Guide”
Step 7 : Loosen the two steel belt tensioning screws.
Step 8 : Remove one steel belt fastening screw.
Step 9 : Remove the steel belt.
Caution :
 Be careful not to cut your finger on the end of the steel belt.
Step 10 : Remove the Y motor assembly (3 screws).
Step 11 : With the pressure lever down, loosen the set screw on the pressure shaft fastening spacer.