Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.4.8 Replacing the Rear Paper Sensor Assembly

Step 1 : Open the Control Box. Refer to “Opening and Closing Control Box”

Step 2 : Remove connector J107 (XR) from the Main Board.

Step 3 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 4 : Remove the Front Cover. Refer to “Removing Front Cover”

Step 5 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”

Step 6 : Remove the Rear Paper Guide. Refer to “Removing Rear Paper Guide”

Step 7 : Remove the Media Keeper while pressing the tabs to the inside.

Caution :

 If you press to hard an on the tabs they will break

Step 8 : Remove the flexible cable keeper. (four fastening screws).

Step 9 : Through the Steel Flexible Guide hole, remove the two fastenings screws holding the sensor

mounting plate.

Step 10 : Remove the sensors from the sensor mounting plate (2 screws) on the Rear Frame X

Reinforcements.

Step 11 : To install the removed components, reverse the removal procedure.