Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.4.7 Replacing the Front Paper Sensor Assembly

Step 1 : Open the Control Box. Refer to “Opening and Closing Control Box”

Step 2 : Remove the Front Paper Guide. Refer to “Removing Front Paper Guide”

Step 3 : Undo the Cable Clamp attached to the front X Reinforcement.

Step 4 : Remove the connector J103 (XF) from the Main Board.

Step 5 : Remove the Front Paper Sensor (2 fastening screws).

Step 6 : To install the removed components, reverse the removal procedure.

Adjustments :

 Carry out Front Head and Cutter Head distance adjustment. (This adjusts the

distance from the leading edge of the media to the printing position)

Please refer to “How to adjust Front-to-Head, Cutter-to-Head Distances”