Specifications

Rockhopper 38 – Maintenance Manual

AP-74038, Rev. 1.1, 25/01/05

4.4.4. Replacing the Lever Sensor Assembly

Step 1 : Remove the Front Paper Guide. Refer to “Removing Front Paper Guide”

Step 2 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”

Step 3 : Remove the Right Cover. Refer to “Removing Right Cover”

Step 4 : Open the Control Box. Refer to “Opening and Closing Control Box”

Step 5 : Disconnect connectors J104 (lever) from the Main Board.

Step 6 : Remove the Panel Cable Connector and Tube Guide (1 fastening screw) and disconnect

connector J301

Nr. Description

1 Connector J301

3 Tube guide

Step 7 : Remove the Panel Mounting Plate (2 fastening screws).

Step 8 : Open the two cable clamps, one attached to the front X reinforcement and one beneath the rear

felt.