Specifications

Rockhopper 38 – Maintenance Manual
50
AP-74038, Rev. 1.1, 25/01/05
4.3.9 Replacing the extended memory (8Mb) (16Mb) (32 Mb)
Caution:
 Switch off the power before performing this operation.
Step 1 : Open the Control Box.
Step 2 : While pulling the stop pins at both ends of the SIMM slot on the Main Board to left and right, push
the SIMM over towards the rear and remove it from the slot.
Step 3 : To install removed components, reverse removal procedure.
Adjustments:
Use self-diagnostic ‘Examination” to confirm memory capacity. Please refer to “Memory
Capacity”.
Standard memory capacity is 8 Mb.
When to 32 MB extended memory boards are added to Slot 1 and Slot 2, memory
capacity will be shows as 72 MB (8+32+32 MB) on the LCD
CAUTION
If only one extended memory is to be installed, it must be installed in Slot 1