Specifications

Rockhopper 38 – Maintenance Manual
212
AP-74038, Rev. 1.1, 25/01/05
No Message N° Checkpoint Action
1.1 • With the printer cover closed, is the
liquid crystal display showing cover
open?
Does the cover switch assy function
work normally with the self-diagnostic
“Examination/Sensors”
→ Adjust cover switch height.
Check cover switch assy
connector J106 (COVER) on
the main board
→ Replace cover switch assy.
1.2 • Check panel cable connectors.
Are they inserted obliquely? Are they
securely locked? Check.
J110 (PANEL) on the main board and
J301 (MAIN) on the panel board
→ Reconnect them.
→ Replace them
1.3 • With the hold lever down, is the liquid
crystal display showing lever up?
→ Check the lever sensor
connector J104 (LEVER) on the
main board.
→ Replace the lever sensor
assy.
1.4 • Check J104 (LEVER) cable
connection on the main board.
→ Re-insert it.
→ Replace the lever sensor
assy.
1.5 • Do the front and rear paper sensors
detect normally with the self-diagnostic
“Examination/Sensors”?
→ Check the connections of the
paper sensor connectors J103
(XF) and J107 (XR) on the main
board.
→ Replace the front and rear
paper sensor assemblies.
1.6 • Carry out “5 V DC Power Supply
Check” and “24, 42 V DC Power
Supply Check”
→ Replace the power board
assy.
1.7 • Is the cable of the switch cable assy
connected properly to J001 on the
power board?
→ Reconnect it.
1.8 • The switch cable board assy may be
faulty.
→ Replace it.
1.9 • Is cable of the DC cable assy
correctly connected to J001 on the
power board and J101 (MAIN) on the
main board?
→ Reconnect them.
→ Replace them.
1
2
3
4
5
• After power is
switched on,
nothing works
• When power is
applied,
“Initializing”
appears and then
a reset is
executed.
• Media is
mounted but the
initialization
operation is not
done
• Printer does not
work even with the
cover closed
• Printer does not
stop even with the
cover opened.
1.10 • The main board assy may be
damaged.
→ Replace it.