Specifications

Rockhopper 38 – Maintenance Manual
20
AP-74038, Rev. 1.1, 25/01/05
4. Cleaning :
 Pressing for 2 seconds initiates the cleaning
procedure.
 When pressed together with the [SHIFT] key
, (9) it
initiates the head adjustment procedure.
 Go to the Previous Menu, when in menu-mode
operation.
 For advanced Cleaning Control, enter the menu
system and select submenu [Utility] – option
[Clean].
5. Quality / Speed :
Pressing QUALITY / SPEED
will change the output quality and
speed. Each time the key is pressed you will notice the LED
indicator showing the current status : High quality, Normal and
High Speed.
 The set-up can only be changed in idle status.
 When pressed together with [SHIFT] key
(9)
outputs the Test Print.
 Go to the Next menu option, or increase a
parameter value when in menu-mode
operation.
 The LED indication is also influenced by data
coming from the RIP/driver software.
6. Resolution :
 Pressing RESOLUTION
will change the output
resolution between 360 DPI, 720 DPI or 1440 DPI.
The set-up can only be changed in idle status.
 When pressed together with the [shift] key
(9) it
allows reverse manual roll feed.
 Select the previous menu option and decrease a
parameter value when in menu mode
operation.
 If both LEDs are ON simultaneously the plotter
operates in one of the 3 available 1440 dpi modes
(horizontal, vertical or diagonal).
 The LED indication is also changed by data
coming from the RIP software.